18 Pathogenicity and Virulence

The ability of a microbial agent to cause disease is called pathogenicity, and the degree to which an organism is pathogenic is called virulence. Virulence is a continuum. On one end of the spectrum are organisms that are avirulent (not harmful) and on the other are organisms that are highly virulent. Highly virulent pathogens will almost always lead to a disease state when introduced to the body, and some may even cause multi-organ and body system failure in healthy individuals. Less virulent pathogens may cause an initial infection but may not always cause severe illness. Pathogens with low virulence would more likely result in mild signs and symptoms of disease, such as low-grade fever, headache or myalgia (muscle aches). Some individuals might even be asymptomatic.

An example of a highly virulent microorganism is Bacillus anthracis, the pathogen responsible for anthrax. B. anthracis can produce different forms of disease, depending on the route of transmission (eg cutaneous injection, inhalation and ingestion). The most serious form of anthrax is inhalation anthrax. After B. anthracis endospores are inhaled, they germinate. An active infection develops, and the bacteria release potent toxins that cause oedema (fluid build-up in tissues), hypoxia (a condition preventing oxygen from reaching tissues) and necrosis (cell death and inflammation). Signs and symptoms of inhalation anthrax include high fever, difficulty breathing, vomiting and haemoptysis and severe chest pains suggestive of a heart attack. With inhalation anthrax, the toxins and bacteria enter the bloodstream, which can lead to multi-organ failure and death of the patient . If a gene (or genes) involved in virulence is inactivated, the bacteria become less virulent or non-pathogenic. This has been shown with the main virulence factors of B. anthracis, pXO1 and pXO2.

Virulence of a pathogen can be quantified using controlled experiments with laboratory animals. Two important indicators of virulence are the median infectious dose (ID50) and the median lethal dose (LD50), both of which are typically determined experimentally using animal models. The ID50 is the number of pathogen cells or virions required to cause active infection in 50% of inoculated animals. The LD50 is the number of pathogenic cells, virions, or amount of toxin required to kill 50% of infected animals. To calculate these values, each group of animals is inoculated with one of a range of known numbers of pathogen cells or virions., To show this, the percentage of animals that have been infected (for ID50) or killed (for LD50) is plotted against the concentration of pathogen inoculated. Figure 6.3 represents data graphed from a hypothetical experiment measuring the LD50 of a pathogen. Interpretation of the data from this graph indicates that the LD50 of the pathogen for the test animals is 104 pathogen cells or virions (depending upon the pathogen studied).

 

Line graph showing that the number of pathogenic agents increases percent of mortality in experimental group
Figure 6.3. A graph like this is used to determine LD50 by plotting pathogen concentration against the per cent of infected test animals that have died. In this example, the LD50 = 104 pathogenic particles. Source: Work by Rice University, OpenStax, licensed under a CC BY 4.0 licence.

Food can also harbour pathogens which can cause food borne illness. ID50 values in humans (as determined from epidemiologic data and studies on human volunteers) and food borne pathogens can also be derived (Table 6.3). The values listed are median values and the actual infective dose for an individual can vary widely, depending on factors such as route of entry, the age, health and immune status of the host and environmental and pathogen-specific factors such as susceptibility to the acidic pH of the stomach. It is also important to note that a pathogen’s infective dose does not necessarily correlate with disease severity. For example, just a single cell of Salmonella enterica serotype Typhimurium can result in an active infection. The resultant disease, Salmonella gastroenteritis or salmonellosis, can cause nausea, vomiting and diarrhoea, but has a mortality rate of less than 1% in healthy adults. In contrast, S. enterica serotype Typhi has a much higher ID50, typically requiring as many as 1,000 cells to produce infection. However, this serotype causes typhoid fever, a much more systemic and severe disease that has a mortality rate as high as 10% in untreated individuals.

Table 6.3a ID50 for selected foodborne diseases caused by viruses

Viral pathogen ID50 (infective dose)
Hepatitus A virus 10-100
Norovirus 1-10
Rotavirus 10-100

Table 6.3b ID50 for selected foodborne diseases caused by bacteria

Bacterial pathogen ID50 (infective dose)
Escherichia coli, enterohaemorrhagic (EHEC, serotype O157) 10-100
E. coli, enteroinvasive (EIEC) 200-5,000
E. coli, enteropathogenic (EPEC) 10 million - 10 billion
E. coli, enterotoxigenic (ETEC) 10 million - 10 billion
Salmonella enterica serovar Typhi <1,000
S. enterica serovar Typhimurium >1
Shigella dysenteriae 10-200
Vibrio cholerae (serotypes O139, O1) 1 million
V. parahaemolyticus 100 million

Table 6.3c ID50 for selected foodborne diseases caused by protozoa

Protozoan pathogen ID50 (infective dose)
Cryptosporidium parvum 10-100
Giardia lamblia 1

 

definition

License

Icon for the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License

Book 2: Biosciences for Health Professionals Copyright © 2026 by University of Southern Queensland is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License, except where otherwise noted.