32 Control of Infection in Healthcare Facilities

Approaches to the control of infection in health-care facilities may vary between institutions but are based in sound microbiological principles and follow the relevant Health Department guidelines for the state or territory. Following HIV and COVID-19, health-care facilities are much more aware of the risks of pathogens both known and unknown and due to possible emerging pathogens, there are a range of guidelines to aid in minimising transmission of microorganisms to protect health care workers and patients. In Australia and in other areas of the world, there are two main levels – standard precautions and transmission-based (additional) precautions.

Standard precautions apply to all patients regardless of infection status ie applies to all pathogens that are likely to be present in any type of body fluid or substance. This covers situations where patients are asymptomatic, diagnostic tests are not available or patients are in a window period of disease (see below).

Download the Standard Precautions Poster [PDF] by Australian Commission on Safety and Quality in Healthcare, licensed under a CC BY-NC-ND 4.0 licence.

Transmission-based (sometimes called additional) precautions are used in addition to the standard precautions to prevent transmission of infectious agents spread via respiratory droplets (droplet precautions), airborne droplet nuclei that can remain in air over time and distance (e.g. aerosols) or via direct or indirect contact with people and/or fomites.

View or download the following posters:

The most important foundation for these precautions is good hand hygiene, which is the single most effective technique to reduce the transmission of infections, including antibiotic-resistant organisms and healthcare-associated infections (HCAI). Hand hygiene is the process of removing, killing or destroying transient microorganisms or visible soiling from hands. There are a number of primary hand-hygiene techniques: handwashing with soap and water, use of alcohol-based hand rub (ABHR) and surgical-hand antisepsis. This last technique is typically reserved for specific medical procedures like surgery.

Healthcare providers’ hands are the most common mode of transmission of microorganisms as they will touch various people and objects when providing care. Microorganisms can easily transfer from their hands to objects in the healthcare setting when proper hand hygiene practices are not followed. When a healthcare provider has physical contact with a patient or client, their personal items, medical equipment or the surrounding environment, they can indirectly transmit microorganisms to the patient/client, another patient/client, themselves, equipment or transfer it to a different environment. Consistent and effective hand hygiene is required to break the chain of transmission.

Handwashing

Originally designed by the World Health Organisation, the five moments of hand hygiene were introduced to show how to minimise the risk of transmission of microorganisms ie to break the chain of transmission, with these principles being applied to all care locations and situations (Figure 7.32). Each health area will have a fully articulated description of these 5 moments but in general are:

  • Moment 1: Before touching a patient.
  • Moment 2: Before a procedure.
  • Moment 3: After a procedure or body fluid exposure risk.
  • Moment 4: After touching a patient.
  • Moment 5: After touching a patient’s surroundings.
Diagram of 5 moments of hand hygiene in different settings including outpatient care, dental care, residential home, vaccination campaign
Figure 7.32. ‘My Five Moments’: a flexible and user-centred approach to hand hygiene in healthcare adopted on a global scale. Source: Image from ‘My five moments’: understanding a user-centred approach to hand hygiene improvement within a broader implementation strategy, by Allegranzi, B., Kilpatrick, C., Sax, H., Pittet, D. from BMJ: Quality and Safety. Originally modified from work(s) by World Health Organization licensed under a CC BY NC-SA 3.0 licence.

Hand Rubbing (Using Alcohol-Based Hand Rub)

When performing hand hygiene using the alcohol-based hand rub (ABHR) technique, a liquid, gel, or foam alcohol-based solution (eg ethanol, isopropanol, or combination) is used. The ABHR should have 70–90% alcohol concentration to be effective. The ABHR is the preferred method to use when hands are not visibly soiled to reduce the number of most transient microorganisms on hands.

Benefits of ABHR:

  • Kills the majority of microorganisms (including viruses) from hands.
  • Are easy to use and have high levels of availability at the point of care (eg where three elements occur together: the patient, the healthcare provider, and care involving the patient).
  • Provides better skin tolerability and reduces skin irritation because it generally contains emollients.
Poster of how to handwash. Step 0 wash hands with water. 1 apply enough soap to cover all hand surface. 2 Rub hands palm to palm. 3. Right palm over left dorsum with interlaced fingers and vice versa. 4. Palm to palm with fingers interlaced. 5. Backs of fingers to opposing palms with fingers interlocked. 6. Rotational rubbing of left thumb claspted in right palm and vice versa. 7. Rotational rubbing, backwards and forwards with clasped fingers of right hand to left. 8. Rinse hands with water. 9. Dry hands thoroughly with single use towel. 10. use towel to turn off faucet. 11. Your hands are now safe.
Figure 7.33. How to handwash? Source: Work by World Health Organization licensed under a CC BY NC-SA 3.0 licence.

 

Poster titled How to handrub, which is a duration of 20-30 seconds. Step 1. apply palmful of product in cupped hand, covering all surfaces. 2. Rub hands palm to palm. 3. Right palm over left dorsum with interlaced fingers and vice versa. 4. Palm to palm with fingers itnerlaced. 5. Backs of fingers too opposing palms with fingers interlocked. 6. Rotational rubbing of left thumb clasped in right palm and vice-versa. 7. Rotational rubbing, backwards and forwards with clasped fingers of right hand in left palm and vice versa. 8. Once dry, your hand are safe
Figure 7.34. How to handrub? Source: Work by World Health Organization licensed under a CC BY NC-SA 3.0 licence.

Hand Hygiene Safety and the moments of hand hygiene should err on the side of caution i.e. if in doubt, wash your hands or use alcohol-based rubs.

Safety Considerations: Factors that Reduce Hand Hygiene Effectiveness

Jewellery

  • Rings and bracelets increase the microbial load on hands, and microorganisms can be protected under and inside jewellery. Rings increase the risk of torn or pierced gloves and should not be worn. Some facility policies allow a single, smooth wedding band. However, all jewellery should be removed during hand hygiene and patient care. If a watch is worn, it should be removed or pushed as high as possible above the wrist to expose the area before performing hand hygiene.

Skin integrity

  • The condition of the hands can influence the effectiveness of hand hygiene and proper skin care is essential for infection control. Skin cracks, dermatitis, abrasions, or cuts can trap bacteria and impact hand hygiene, thereby placing patients, healthcare providers and the environment at increased risk of infection. .
  • Nail length: Nails should be short, clean, and not extend past the end of the finger. Most microbes on hands come from under the fingernails. Subungual areas (under the fingernails) can harbour higher concentrations of microorganisms. In addition, long nails are harder to clean and may lead to more frequent punctures in gloves from the thumb and forefinger.

Nail polish

  • Nail polish, if worn, should be freshly applied and be free from chips or cracks. Studies have shown that chipped nail polish and polish older than four days can harbour microorganisms.

Artificial nails and nail enhancements

  • Artificial nails and nail enhancements increase the risk of transferring microorganisms, tearing gloves, and poor hand hygiene practices.

Water temperature and products

  • Use warm water. Hot or cold water increases the likelihood of skin damage, increase the risk of dermatitis, can lead to dryness, and acts as an irritant.
  • Water alone is not sufficient to clean soiled hands; an adequate amount of soap is required to dissolve fatty materials and oils from hands and serve as mechanical lubricant to decrease microbial load.
  • To prevent contamination, products must be dispensed in a disposable, single-use pump container and should be discarded when empty. Bars of soaps should not be used by healthcare providers in healthcare facilities.
  • Do not use ABHR in combination with soap and water, as it may increase skin irritation and decrease effective microbial control.
  • Use ABHR that contains emollients (oils) to help reduce skin irritation and over-drying.
  • Allow hands to dry completely before initiating tasks (eg touch patient or environment) or applying clean or sterile gloves.
  • ABHR may be used for all five moments of hand hygiene, as long as hands are not contaminated or visibly soiled.
  • DO NOT use ABHR if the client is suspected to have or confirmed with C. difficile, norovirus, or Bacillus anthracis. ABHR will not kill endospore-forming pathogens.

Specific Problems in Infection Control – Dealing with the Unknown

Infection control is more that dealing with known pathogens in a controlled environment. Emergency departments (EDs) are a high infectious risk environment as it is unknown what type of organisms may be present in or on those attending EDs. Surgical procedures also carry a risk of infection, especially long procedures and surgical staff have rigorous infection control strategies to minimise this risk. Other areas in a health care facility where patients are more prone to infection are in burns units (where skin integrity has been lost), intensive care units (seriously ill, catheterised or ventilated), maternity wards and paediatric wards (fomites and respiratory secretions). Also, the areas where there are immunocompromised patients such as transplant and oncology wards and aged care facilities. All these areas require robust infection control procedures to minimise risk of infection of the very ill and the immunocompromised.

References:

Allegranzi, B., Kilpatrick, C., Sax, H. & Didier, Pittet. (2022). ‘My five moments’: Understanding a user-centred approach to hand hygiene improvement within a broader implementation strategy. BMJ Quality & Safety, 31:259-262. https://doi.org/10.1136/bmjqs-2021-013680.

definition

License

Icon for the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License

Book 2: Biosciences for Health Professionals Copyright © 2026 by University of Southern Queensland is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License, except where otherwise noted.